Fixing The Unit To The Pole Mount Adapter Or Corner Mount Adapter; Fixing With Pole Mount; Fixing With Corner Adapter - Videotec MAXIMUS MVX Manuel D'instructions

7.5.3 Fixing the unit to the pole mount
adapter or corner mount adapter
To install the product on a pole or at a wall corner,
first of all fix the unit to the wall bracket (7.5.2 Bracket
mounting, page 18).

7.5.3.1 Fixing with pole mount

Fix the wall bracket to the pole mount adapter
using 4 washers, 4 stainless steel grower washer
and 4 hexagon stainless steel bolts (A4 class 70)
M10x30mm.
Make sure the thread are free of dirt and debris.
Apply a generous amount of threadlocker (Loctite
270) on the 4 threaded holes on the pole mount
adapter.
Tighten the screws.
Pay attention to the fixing. Tightening
torque: 35Nm.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
Fig. 10
MNVCMVXTHD_1813_EN

7.5.3.2 Fixing with corner adapter

Fix the wall bracket to the corner mount adapter
using 4 washers, 4 stainless steel grower washers
4 hexagon stainless steel bolts (A4 class 70)
M10x30mm.
Make sure the thread are free of dirt and debris.
Apply a generous amount of threadlocker (Loctite
270) on the 4 threaded holes on the corner module.
Tighten the screws.
Pay attention to the fixing. Tightening
torque: 35Nm.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
Fig. 11
19