6.4.3 Fixing the unit to the pole mount
adapter or corner mount adapter
To install the housing on a pole or at wall corner,
first of all secure the wall bracket (6.4.2 Fixing with
bracket, page 17).
6.4.3.1 Fixing with pole mount
Fix the wall bracket to the pole mount adapter
using 4 washers, 4 stainless steel grower washer
and 4 hexagon stainless steel bolts (A4 class 80)
M10x30mm.
Make sure the thread are free of dirt and debris.
Apply a generous amount of thread locking
compound (Loctite 270).
Tighten the screws.
Pay attention to the fixing. Tightening
torque: 35Nm max.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
Fig. 10
18
6.4.3.2 Fixing with corner adapter
Fix the wall bracket to the corner mount adapter
using 4 washers, 4 stainless steel grower washers
4 hexagon stainless steel bolts (A4 class 80)
M10x30mm.
Make sure the thread are free of dirt and debris.
Apply a generous amount of thread locking
compound (Loctite 270).
Tighten the screws.
Pay attention to the fixing. Tightening
torque: 35Nm max.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
Fig. 11
6.4.4 Adjusting the protection grille
The protection grille may be adjusted moving it
upwards, to fit it with the field of view of certain
cameras.
Fig. 12
MNVCMHX_1432_EN