Bracket Mounting; Fixing The Unit To The Pole Mount Adapter Or Corner Mount Adapter; Fixing With Pole Mount - Videotec Série 2 Manuel D'instructions

6.5.2 Bracket mounting

The bracket can be fixed to the vertical wall. Use
screws and wall fixing devices that can bear at least
four times the weight of the unit.
Fasten the device to the bracket by using 4 flat
washers, 4 serrated stainless steel washers and
4 stainless steel hex head screws (A4 class 70)
M10x20mm supplied.
Make sure the thread are free of dirt and debris.
Apply a generous amount of thread locking
compound (Loctite 270) on the 4 screws.
Tighten the screws.
Pay attention to the fixing. Tightening
torque: 35Nm.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
Fig. 8
Fig. 9
16
150
6.5.3 Fixing the unit to the pole mount
adapter or corner mount adapter
To install the product on a pole or at a wall corner,
first of all fix the unit to the wall bracket (6.5.2 Bracket
mounting, page 16).

6.5.3.1 Fixing with pole mount

To fix the wall support bracket to the pole sling, use
the 4 flat washers, the 4 grower washers in stainless
steel and the 4 hexagonal head screws in stainless
steel (A4 class 70) M10x30mm supplied.
Make sure the thread are free of dirt and debris.
Apply a generous amount of threadlocker (Loctite
270) on the 4 threaded holes on the pole mount
adapter.
Tighten the screws.
Pay attention to the fixing. Tightening
torque: 35Nm.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
Fig. 10
MNVCNXPTZ2_2032_EN