Fixing With Bracket; Fixing The Unit To The Pole Mount Adapter Or Corner Mount Adapter; Fixing With Pole Mount - Videotec MAXIMUS MPXHD Manuel D'instructions

5.5.2 Fixing with bracket

The bracket can be fixed to the vertical wall. Use
screws and wall fixing devices that can bear at least
four times the weight of the unit.
To fix the device to the bracket, use 4 plane washers,
4 stainless steel grower washer, 4 socket head
stainless steel screw provided.
Fig. 6
Make sure the thread are free of dirt and debris.
Apply a generous amount of thread locking
compound (Loctite 270) on the 4 screws.
Tighten the screws.
Pay attention to the fixing. Tightening
torque: 35Nm.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
14
5.5.3 Fixing the unit to the pole mount
adapter or corner mount adapter
To install the component on a pole or at a wall corner,
first of all fix the pan & tilt unit to the wall bracket (
5.5.2 Fixing with bracket, page 14).

5.5.3.1 Fixing with pole mount

Fix the wall bracket to the pole mount adapter
using 4 washers, 4 stainless steel grower washer
and 4 hexagon stainless steel bolts (A4 class 80)
M10x30mm.
Fig. 7
Make sure the thread are free of dirt and debris.
Apply a generous amount of threadlocker (Loctite
270) on the 4 threaded holes on the pole mount
adapter.
Tighten the screws.
Pay attention to the fixing. Tightening
torque: 35Nm.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
MNVCMPXHD_1607_EN