Mondolfo Ferro AS944TI Manuel D'utilisation page 39

7.7.c. INFLATING TUBELESS TYRES (TI VERSION ONLY)
Before carrying out the operations described below, always make sure that there is no
dirt, dust or other impurities on the jaws near the air outlet holes.
- Make sure that the wheel is secured to the table top with inside clamping Fig. 32).
- Connect the Doyfe connector on the air hose to the valve stem (Fig. 30).
- Hold the tyre with your hands and lift it until there
is a slight gap between the lower bead and bottom
edge of the rim in order to close the upper bead
and the top of the rim (fig. 33).
- Fully press the inflation pedal down for a short
period to the bead seating position (fig. 34). The
tyre will expand and the beads will seat.
- Release the wheel from the sliding clamps on the
table top (Fig. 35).
- Bring the horizontal arm to the fully extended
position.
- Lower the vertical rod until it touches the rim
(Fig. 30).
- Lock the horizontal arm and the vertical rod in
this position.
Inflate the tyre by operating the proper pedal in in-
flation position (average) (Fig. 31) at short intervals;
check the pressure gauge frequently to make sure
that the pressure NEVER exceeds the maximum
pressure specified by the tyre manufacturer.
YES
AS 944 TI User Manual
WARNING
NO
35
32
33
34
39