Mondolfo Ferro AS944TI Manuel D'utilisation page 30

- Adjust the opening of the bead breaking
shoe by turning the screw located on the
cylinder stem (fig.15).
- Position the wheel as shown in fig.16 and
move the bead breaking shoe near the
rim edge.
IMPORTANT: During the bead breaking
operation, you are advised to keep the
turntable closed (clamp gripper towards
the centre) (fig.16a).
- Press the pedal
the bead breaker and detach the bead.
- Repeat this operation on the other side
of the wheel.
After detaching the beads, remove the
old balancing weights.
- Thoroughly lubricate the sides of the tyre
around the entire circumference of the
lower and upper bead (fig.17).
30
(fig.16b) to operate
16a
15
16
16b
17
AS 944 TI User Manual