Publicité
Les langues disponibles
Les langues disponibles
7.
System settings
Call up the service menu
'
See page 21.
)* With SANARIUM controller 18033/18040 with function.
)* With Sauna controller 18029/18040 without function (changes to these values are
not applied).
7.3.
Service menu 02 - VERS, software version
Display:
Time in hours that the controller has been connected to the mains.
7.4.
Service menu 03 - PUR, SaunaP
Input:
0
=
SaunaP
disabled
UR
2
=
SaunaP
enabled
UR
.
The SCS can be connected to
the controller if the internal
display FAI 4/FAI 5 is
connected.
7.5.
Service menu 04 - CO- 1, humidity sensor )*
Input:
Use the symbols +/- to successively enter the two three-digit parameters from the humidity sensor into
the corresponding storage location C0-/C1.
Both parameters (C0 and C1) are noted down by hand on the PCB of the humidity
sensor.
To see the parameters, remove the housing cover of the humidity sensor and note
down the two parameters.
Confirm the inputs by pressing the OK symbol after each one.
7.6.
Service Menu 05 - TIME, bathing time
Input:
01
PAGE 22
Bathing time in hours
03
04
UR
1
=
SaunaP
enabled
UR
.
Connect SCS to Klafs IMES-1
with SaunaP
3
=
Gas sauna heater control algorithm.
06
12
Sauna/SANARIUM
mode enabled.
UR
18
50701290/12.14
Publicité
