Klafs 18029 Manuel De Service page 36

8. If something does not work
8.2. Other possible errors
Fault
The InfraPLUS
heaters will not
switch on.
The WLAN symbol
does not appear
or flashes for
more than
30 seconds.
PAGE 36
Cause
The incorrect bathing mode
has been selected.
The temperature in the cabin
is greater than 50 °C.
The InfraPLUS heater is not
being supplied with power.
There is no WLAN module
installed in the controller.
The WLAN module that has
been installed has not been
activated in the controller's
system settings.
The WLAN module that has
been installed is defective.
The dot in the WLAN symbol
flashes for more than
30 seconds.
The WLAN module that has
been installed is defective.
The WLAN symbol flashes
for more than 30 seconds.
The WLAN module is unable
to connect to the local
wireless network.
The WLAN module has not
been configured correctly.
Sauna/SANARIUM
Remedy
Select InfraPLUS mode.
'
See controller 180xx.
Open the cabin door and allow the
temperature to fall.
Check the fuse in the power supply.
Switch the power supply on.
'
Install a WLAN module; see the
installation instructions for the controller.
'
Activate the WLAN module; see
page 28 of the installation instructions
for the controller.
Switch the controller's main switch off and
on again.
If the symbol does not display any other
status, the WLAN module that has been
installed is defective.
'
Replace the defective WLAN module;
see the installation instructions.
There is no connection to the local wireless
router.
Switch on or check the local wireless
network.
Check the configuration of the WLAN
module or reconfigure the WLAN module.
'
Configure the WLAN module; see the
operating instructions for the WLAN
module.
Continued
50701290/12.14