Publicité
14. TROUBLESHOOTING GUIDE
14. FEHLERSUCHE
14. RECHERCHES DE PANNES
14. GUIA PARA LA LOCALIZACION DE FALLAS
Problem
10. Trailing lengths of the
upper threads are too
short after thread trim-
ming.
Hook
11. Thread wiper is hitting the
needles.
Needle up stop position is
not consistently the same.
12. Broken needles
All manuals and user guides at all-guides.com
¡
Is the thread coming out of the cotton stand easily?
If the thread is not coming out easily, check if the thread is caught
on something.
¡
Is the tension of the pretension too strong?
Adjust the pretension.
¡
Are the thread take-up spring tensions too strong?
Make the thread take-up spring tensions weaker.
¡
Are the ranges of movement for the thread take-up springs too large?
Reduce the ranges of movement of the thread take-up springs.
¡
Are the hooks of the movable knives damaged?
Polish the hooks to remove the damage, or replace the damaged
knife.
¡
Are the tension discs moving during thread trimming?
If the tension discs are not moving, adjust the tension release mecha-
nism.
¡
Is the timing correct during thread trimming?
Adjust the timing for thread trimming.
¡
Is the thread wiper correctly positioned?
Adjust the thread wiper.
¡
Is the needle up stop position too low?
Adjust the needle position sensor.
¡
Is the V-belt tension too weak?
Adjust the tension so that the V-belt shows a deflection of 10–20 mm
when pushed with a finger.
¡
Is the material being pushed or pulled with excessive force during
sewing?
If the needle tip is bent or broken, replace the needle.
¡
Does the needle pass the center of the needle hole in the feed dog?
Check the needle down position. If the needle does not drop into the
middle of the needle hole in the feed dog, re-install the feed dog.
[842B, 847B, 872B]
If the needle bar has been turned, turn it again to set it to the cor-
rect position.
Caution
¡
It is extremely dangerous to leave any pieces of broken needle
sticking in the material. If the needle breaks, search for all pieces
until the whole of the needle is found again.
¡
Furthermore, we recommend that thorough steps be taken to ac-
count for such needles to comply with product liability regula-
tions.
– 105 –
Where to check
Page
44
52
65
66
78
81
85 · 86
75
83
18
91
(Step 3)
TN-840B, 870B (English)
TL-840B
(English)
Publicité
