Xylem Lowara GEM Traduction De La Notice Originale page 99

8.3.5 Connection to a PC and mobile devices
Connect the panel to a PC or mobile device to:
• Transfer parameters from the panel to the PC or mobile device, and vice versa
• Set data and features
• Load language settings in addition to the default ones.
For more information, refer to the Control Display Operating Manual.
PC
1. Install the Xpress software on your PC.
2. Insert the IR-USB stick into the IR-USB programming port on the panel.
3. Connect the PC to the stick with a cable with USB plug.
Mobile device
1. Install the
2. Set the selector switch to MAN.
3. Enter the advanced PIN if required.
4. Open the app.
5. Place the device on the NFC port until the beep is heard: the application starts
8.3.6 Settings Parameters
NOTE:
The control panel is supplied already programmed. The parameters must only be changed by
qualified personnel. Failure to observe the warnings may cause damage to the pump set and
make the warranty null and void.
For more information, refer to the Control Display Operating Manual. Contact Xylem or the
Authorised Distributor if special parameters are required.
Access to the menus
1. Set the selector switch to MAN.
2. Press  to access the main menu.
3. Press ▲or ▼ to select the setup icon.
4. If necessary, enter the access PIN.
5. Press  to access the SETUP MENU.
6. Press ▲ or ▼ to select the desired submenu.
7. Press  to access the submenu: the figure shows an example.
GEM, GEMJ – Fire-fighting Pump Set
Lovato Nfc
app on your Android™ device.
automatically and the parameters are loaded and displayed.
1. Parameter code
2. Selected parameter
3. Parameter description
4. Current value
en – Original Instructions
99