Publicité
Les langues disponibles
Les langues disponibles
en – Original Instructions
5 Mechanical Installation
5.1 Precautions
Before starting, make sure that the safety instructions shown in Introduction and Safety on
page 65 have been fully read and understood.
WARNING:
All the hydraulic and electrical connections must be completed by a technician possessing the
technical-professional requirements outlined in the current regulations.
WARNING:
Always wear personal protective equipment.
WARNING:
Always use suitable working tools.
CAUTION:
Handle the pump set components in compliance with the current regulations on "manual load
handling", to avoid undesirable ergonomic conditions causing risks of back-spine injury.
5.2 Pump set installation
1. Check that the supports for alignment to the GEMK module, if required and depending on
2. Secure the pump set to the floor with bolts that are:
80
the model, are installed in the correct position. See the figure below and table 1.
• Appropriate
• Suitable for the support material and the application conditions.
The figure below and table 1 show the dimensions and spacing of the holes, depending on
the model.
Note: for models not indicated in the table contact Xylem or the Authorised Distributor.
A
GEM, GEMJ – Fire-fighting Pump Set
B
Publicité
