Publicité
Les langues disponibles
Les langues disponibles
en – Original Instructions
Lifting and positioning the pump set
1. Slowly lift and move the pump set.
2. Before placing the pump set on the ground, if required fit the supports for alignment to the
3. Slowly place the pump set on the ground, following the measurements shown in figure.
4. Release the ropes from the eyebolts/eyelets.
5. Remove the eyebolts.
Lifting and positioning the cabinet-type control panel
1. Remove packing materials from the product.
2. Separate the control panel from the pallet by cutting the straps.
3. Attach the ropes to the eyelets; see the figure below.
4. Fix the ropes to the crane.
5. Slowly lift and move the control panel.
6. Slowly place the control panel on the ground, following the measurements shown in figure 1.
7. Release the ropes from the eyelets.
72
GEMK module.
L1
L2
Figure 1: Positioning the pump set and the cabinet-type control panel
Position
Description
number
L1
The minimum distance between the pump set and the walls may vary according to the
provisions of the applicable local laws
L2
Maximum distance between the pump set and the cabinet-type control panel
L1
L2
Measurement, m (ft)
≥ 0.8 (2.5)
≤ 5 (16)
GEM, GEMJ – Fire-fighting Pump Set
Publicité
