Porsche Mobile Charger Plus Mode D'emploi page 60

Set up
H
CEI 23-16-VII
Type L 16 A (5 mm)
I
IA6A3 (BS 546)
Type M
NEMA 6-50/NEMA 14-50 (additional infor-
mation)
Information
Scope
This usage recommendation applies only to regions
with NEMA 6-50/NEMA 14-50 standard.
Charging your vehicle may result in high electric cur-
rents. For safety reasons, it is absolutely essential
that you use only components approved for this and
that the entire charging equipment is installed cor-
rectly.
58
General safety instructions
Electric shock and fire!
DANGER
Incorrect use of the charging equipment and failure
to observe the installation and safety instructions can
lead to a short circuit, electric shock, explosion, fire or
burns.
e
Pay attention to the installation instructions in
the charging equipment manual.
e
Pay particular attention to all safety and warning
notices there.
e
Have the installation carried out by a person with
the necessary electrical training and specialist
knowledge.
e
Also observe the national regulations for carrying
out electrical installations.
Requirements for power socket
Unsuitable mains sockets
DANGER
An unsuitable mains socket can cause a short circuit,
electric shock, explosion, fire, or burns.
e
Only use only a type of mains socket that is
suitable for this installation (see Suitable types
of mains sockets/power plugs).
e
Only use mains sockets that meet the require-
ments for the quality of contact surfaces and
fastening (see Requirements for the quality of
mains sockets).
e
Avoid direct contact between the terminal
screws and the wire. Preferably, use wire end
ferrules.
e
Avoid jamming the cable on the insulation.
Suitable mains socket/grid plug types
NEMA 6-50
Socket/connector
NEMA 14-50
Socket/connector
Requirements for the quality of the mains sockets
A Contact surface only half plug contact height
B Contact surface over the entire plug-in contact
height
C Small contact surface between clamping screw
and strand.
D Width of contact surface between clamping plate
and strand