Télécharger Imprimer la page

Porsche Mobile Charger Plus Mode D'emploi page 57

Masquer les pouces Voir aussi pour Mobile Charger Plus:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 85
Fig. 28: Drilling dimensions
1. Remove the connector fastener 1 (Fig. 28) from
the cover 2 (Fig. 28).
2. Mark the drill holes on the wall.
3. Drill the mounting holes and insert wall plugs.
4. Screw the connector fastener 1 (Fig. 28) onto
the wall.
5. Fit the cover 2 (Fig. 28) onto the connector fas-
tener 1 (Fig. 28) from below and push up.
Attaching the control unit to the wall
mount
Fig. 29: Attaching the control unit
1. Route the vehicle cable through the lower open-
ing of the basic wall mount, place the bottom of
the control unit on the locking tab and push back
to engage.
2. Guide the supply cable through the upper open-
ing in the basic wall mount and lock the circlip by
pushing it to the left.
3. Insert the vehicle plug in the connector fastener.
Set up
Vehicle charging cables and supply
cables
Information on vehicle charging cables
and connectors
Different vehicle charge ports A and vehicle plugs B
are available depending on the vehicle equipment.
IEC 62196-2/
SAE-J1772-2009
Type 1 UL/IEC
IEC 62196-2
Type 2
Selecting a Supply Cable
For regular charging with optimum charging speed,
use only the supply cables listed below. The maxi-
mum achievable charging power is up to 11 kW (de-
pending on the device variant, national regulations,
mains/home connection and on-board charger).
NOTICE
Use only supply cables approved for the relevant
country. When driving abroad, always carry the ap-
propriate supply cable with you for use in the country
you are visiting.
Set up
55

Publicité

loading