Abus TERXON M Instructions D'installation page 181

Test function
090 Event memory
The alarm centre stores the last 250 events. Each event is
stored with date and time. The event memory can be viewed
via the program menu.
1. On the control unit, enter:
2. The LCD display shows the latest events first.
3. You can page forwards and backwards in the event
memory. Press key 1 to page forwards and key 3 to
page backwards.
4. Press to switch between the event and the date.
5. Press to exit the event memory.
6. The event memory cannot be deleted by the
programmer or the user.
Entries in the event memory and their meaning:
Entry Meaning
MAINS Fail Failure of 230V AC power supply
MAINS Fail 230V AC power supply restored
OK
Alarm Abort Alarm aborted manually by user
AUX DC Fail 12V DC power supply failed or AUX fuse
defect
AUX DC Fail 12V DC power supply restored
OK
Bad Error in alarm centre memory
Checksum
Batt Load Fail Failure of battery charger or battery fuse
defect
Batt Load Fail Battery charger restored
OK
Burg Zone nn Zone nn has triggered a burglar alarm
Burg Zone nn Zone nn OK
OK
Defaults Factory settings restored
Loaded
EEPROM Fail Memory error in the alarm centre
090
85
Fire Zone nn Zone nn has triggered a fire alarm
Fire Zone nn Zone nn reset
OK
Fire OK Fire alarm reset
Excess Keys A user has tried too often to enter code in
the control unit
Keyboard Control unit nn failed
Missing
Keyboard Control unit nn reconnected
Restore
Keyboard Control unit has triggered a tamper alarm
Tamper
Keyboard Control unit nn tamper reset
Restore
Fire Zone Fire alarm triggered at control unit nn
Alarm
Medical Zone Medical emergency alarm triggered at
Alarm control unit nn
Key Sw Set # Alarm centre activated via key switch of
zone nn
Entry Meaning
Key Sw Unset Alarm centre deactivated via key switch of
# zone nn
Key Box Cls Zone nn with key box property closed
Z#
Key Box Opn Zone nn with key box property opened
Z#
Lid Tamper The lid contact of the alarm centre was
triggered
Lid Tamper The lid contact of the alarm centre is
Restore closed again
Batt missing Battery supply interrupted (cable not
plugged in)
Batt Flt Restore Battery supply restored (cable connected)
PA K -- Alarm BDT nn has triggered a panic alarm
PA Z -- Alarm Zone nn has triggered a panic alarm
PA Z -- Rstr Panic alarm of zone nn reset
Set Fail Zone - The alarm centre could not be activated
- since ZN nn was triggered
Fire Z – Alarm Zone nn has triggered a fire alarm
Fire Z -- Rstr Zone nn fire alarm reset
Soak Fail Z -- Zone nn sensor test failed
UK