Abus TERXON M Instructions D'installation page 162

13
UK
14
15
16
17
Only in partitioned system
18
19
20
21
22
Unset 1
This output is activated for a definable
time period (command 172) if the alarm
centre is deactivated completely (A) or
internally (B), (C) or (D) (command 171).
Confirm
This output is active during a confirmed
alarm.
Set Comp1
This output is active for 10 seconds after
the system has been activated.
Unset Comp1
This output is active for 10 seconds after
the system has been deactivated or after
an alarm has been deactivated.
System Alarm
This output is activated when the alarm
centre has detected an alarm.
Bell Pa
This output is active when an alarm has
been detected in partition A.
Bell Pb
This output is active when an alarm has
been detected in partition B.
Bell Pc
This output is active when an alarm has
been detected in partition C.
Bell Pd
This output is active when an alarm has
been detected in partition D.
Strb Set Pa
This output is active for 10 seconds after
partition A has been activated.
Strb Set Pb
This output is active for 10 seconds after
23
partition B has been activated.
Strb Set Pc
This output is active for 10 seconds after
24
partition C has been activated.
Strb Set Pd
This output is active for 10 seconds after
25
partition D has been activated.
Set 1
This output is activated for a definable
time period (command 170) if the alarm
26
centre is activated completely (A) or
internally (B), (C) or (D) (command 171).
Set 2
This output is activated for a definable
time period (command 170) if the alarm
27
centre is activated completely (A) or
internally (B), (C) or (D) (command 171).
Set 3
This output is activated for a definable
time period (command 170) if the alarm
28
centre is activated completely (A) or
internally (B), (C) or (D) (command 171).
Set 4
This output is activated for a definable
time period (command 170) if the alarm
centre is activated completely (A) or
29
internally (B), (C) or (D) (command 171).
The output is also activated if a fire or
panic alarm is triggered.
Unset 1
This output is activated for a definable
time period (command 170) if the alarm
30
centre is deactivated completely (A) or
internally (B), (C) or (D) (command 171).
66