Abus TERXON M Instructions D'installation page 141

Settings in program menu
000 Country Settings
Use this setting to configure the burglar alarm centre for the
local country. When you load the country settings, all user-
defined settings are discarded. If you only want to set the
language of the control unit display, use menu item 126
(language).
At the user level, do the following:
1. On the control unit, enter:
2. Enter the program code:
The LCD display shows: Progr.Mode
3. On the control unit, enter:
4. The LCD display shows: 000:Land=D
5. On the control unit, enter:
6. The LCD display shows: 000:Land=UK
7. On the control unit, enter:
8. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode
You have now made the settings for Germany. Following this
setting, the values mentioned of the program overview are
different from the values set on the burglar alarm centre.
001 – 016, X17 – X32 Zone setting
Under the zone setting menu item, set the zone name and
property.
From the program level, do the following:
1. On the control unit, enter:
2. The LCD display shows: 001: ZONE 01
3. The cursor flashes under the first letter.
0
7890
000
0
001
4. Enter the zone name (max. 12 characters) via the
keypad.
5. In the following, the zone name "EINGANG" is
entered.
On the control unit, enter:
6. If you make a mistake, you can move the cursor back
by pressing the D key
7. You can delete a letter or digit by entering a blank at
the respective position with the 0 key
8. After entering a new zone name, confirm your input.
On the control unit, enterr:
45
- E
- next position ->
- I
- next position ->
- N
- next position ->
- G
- next position ->
- A
- next position ->
- N
- next position ->
- G
.
.
.
UK