Publicité
Les langues disponibles
Les langues disponibles
8. Now enter via the control unit:
programming code
The following shows on the display: Mult Syst?
9. Press Key 1 to create a partitioned system.
UK
Press Key 0 to create a single system like we do.
10. The display shows: PROGR. MODE
11. You are now in the program menu of the burglar alarm
panel and can start programming
First we program the two zones.
On the keypad, enter 001 followed by
to Zone 1 (motion sensor). You see the following display:
You can now change the zone name "Zone01" using the
keypad of the control unit. The keys are similar in operation to
those of a mobile phone. Press C to move one place
forwards, and D one place back (see page 45).
Now press the Enter key
Define Zone 001 as "immediate" by entering 03. You see the
following display:
By pressing keys A, B, C, D, you can change the assignment
of the sensor to the individual areas. . In this programming
example the detector works only when the hole system is
activated.. Now confirm your input by pressing
returned to the start screen of the programming menu.
Now enter 002 for programming Zone 2, followed by
You see the following:
Change the name of the zone according to your wishes and
then press the Enter key
and then the factory-set
0
7890
.
to make settings
; the following appears:
. You are
. You see the following:
We will now change this to entry/exit. Enter 05. You see the
following in the display:
Now press B to add area B to the sensor. Confirm your setting
by pressing the Enter key
The "1" following the sub-areas stands for the time delay
group (1 to 4). You can change this at any time in the
programming menu (menu items 201 to 204, see page 82).
You now have to program the key switch to Zone 3. Enter
003, change the zone name if required, and press the Enter
key
. The display shows the following:
Change the zone by entering 11 in the key switch, and the
following appears:
Confirm your input with
(004 to 008) are marked as "Not Used" (NU). You can set a
zone by entering 00.
In the next step, we set the exit delay time. This is the time
available for leaving the secure area before the alarm system
is activated.
In programming mode, enter 044 on the keypad, followed by
. The display shows:
Enter an exit delay time (1 for 10 sec. to 6 for 120 sec.) and
confirm with
.
Set entry delay time under menu item 201.
.
In this example, you have 45 seconds to deactivate the armed
alarm system.
You can choose values from 10 to 120 sec. 1 stands for 10
and 6 for 120 seconds. After your selection, press
26
.
. Note that non-connected zones
.
Publicité
