Abus TERXON M Instructions D'installation page 126

First-time usage
Putting into operation
If you want to create your own configuration of the system
UK
and do not need the example of installation pay attention to
the next steps. Please take notice of the important terms
concerning the alarm panel. You can now put the alarm
panel into operation.
1. Connect the 12V battery (7.0 Ah) to the contacts of
the alarm centre (note the colour code:
red = +12V, black = 0V).
2. Using a screwdriver, short-circuit the two pins of
the kick-start jumper (see p. 14).
3. The green LED for the power supply (
to flash and the buzzers of the control units can be
activated. You can ignore the display messages.
4. Enter the factory-set user code.
This is:
messages.
5. First close the housing of the burglar alarm panel
securely before switching on the 230V voltage.
6. Switch on the 230V mains voltage to the burglar
alarm panel.
7. The green LED for the voltage (
constantly.
8. Now enter via the control unit:
factory-set programming code
The following shows on the display: Mult Syst?
9. Press Key 1 to create a partitioned system.
Press Key 0 to create a single system.
10. The display shows: PROGR. MODE
11. You are now in the program menu of the burglar
alarm panel and can start programming
. You can ignore the display
1234
) now lights
and then the
0
7890
) begins
.
30