Abus TERXON M Instructions D'installation page 152

12. Confirm your input with
13. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
052 Block tamper
UK
Proceed as follows to change the property of the tamper
alarm:
1. On the control unit, enter:
2. The LCD display shows: 052:Omit Alarm
3. Via the keypad, select from the following items and
press:
0
1
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
053 Cancel - Reset
To change the property of the alarm reset:
1. On the control unit, enter:
2. The LCD display shows: 053:Abort=System
3. Via the keypad, select from the following items and
press:
0
1
4. Confirm your input. On the control unit, enter:
.
052
Omit Alarm
You can only block some zones; a tamper
zone or a tamper alarm cannot be
blocked.
Omit Al+Tamp
You can block some zones and tamper
zones or a tamper alarm from monitoring.
053
Abort=System
Resetting after a cancelled alarm is as set
in function 33.
Abort=User
The user may make a reset after a
cancelled alarm.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
054 BVVO monitoring
To change the property of the BVVO monitoring:
1. On the control unit, enter:
2. The LCD display shows: 054: BVVO Sup OFF
3. Via the keypad, select from the following items and
press:
BVVO Sup OFF
If a radio transmitter can no longer be
reached by the alarm centre then this
0
reports a monitoring error after 1 hour
(see function 128).
BVVO Sup ON
If a radio transmitter can not be reached
for more than 15 minutes then a warning
is displayed on the control unit if an
attempt is made to activate it. If the
1
transmitter can not be reached for more
.
than 2 hours then the alarm centre
reports: „detector tampering", (when
activated) external alram; „monitoring
error", (when deactivated) internal alarm.
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
056 Length of access code
To change the property of the length of the access code:
1. On the control unit, enter:
2. The LCD display shows: 056: 4 Digit
3. Via the keypad, select from the following items and
press:
4 Digit
0
6 Digit
1
.
4. Confirm your input. On the control unit, enter:
56
054
.
056
.