Abus TERXON M Instructions D'installation page 145

5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
028 Status display
Proceed as follows to change the property of the status
display:
1. On the control unit, enter:
2. The LCD display shows: 028:Status OFF
3. Via the keypad, select from the following items and
press:
Status OFF
The display is permanently on. The system
0
always shows whether the alarm centre is
activated or deactivated.
Status ON
The status display of the alarm centre
remains active for 180 seconds after entry
1
of the user code, and then changes to
date and time display.
Status Code
30 seconds after each event, the display
changes back to date and time display.
2
Note that the LEDs also light for 30
seconds.
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
029 Entry alarm delay
Proceed as follows to change the property of the entry alarm
delay:
1. On the control unit, enter:
2. The LCD display shows: 029:Delay OFF
3. Via the keypad, select from the following items and
press:
Delay OFF
The alarm centre generates an immediate
0
alarm if the user deviates from the
028
.
029
49
specified entry route.
Delay ON
The alarm centre extends the entry delay
by 30 seconds if the user deviates from
the specified entry route. An internal alarm
is triggered to inform the user that he/she
1
has made a mistake. If the user code is
entered within the delay time, a local
alarm is prevented and the alarm centre is
reset.
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
030 Panic silent
To change the property of the silent panic alarm:
1. On the control unit, enter:
2. The LCD display shows: 030:PA audible
3. Via the keypad, select from the following items and
press:
PA audible
When a panic alarm is triggered, the
0
alarm centre generates a local alarm.
PA silent
When a panic alarm is triggered, the
alarm centre generates no local alarm.
1
The alarm is issued only via the relay
contacts and via the optional dialler.
6. Confirm your input. On the control unit, enter:
7. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
031 Zone tamper
Proceed as follows to change the property of zone tampering:
1. On the control unit, enter:
2. The LCD display shows: 031:EngTmpRstOFF
.
030
.
031
UK