1
UK
6. Confirm your input. On the control unit, enter:
7. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
039 Exit mode for overall activated (A)
To change the property of the exit mode for overall activated:
1. On the control unit, enter:
2. The LCD display shows: 039: A=Timed
3. Via the keypad, select from the following items and
press:
4.
0
1
2
3
code.
EnSysTmp ON
In the event of a system sabotage, you can
reset the alarm centre by entering the
installer code.
039
A=Timed
After the alarm centre is activated, the
programmed exit delay time starts. At the
end of the delay time, the alarm centre is
activated. If zones are open at this time,
an alarm is triggered.
A=Terminated
After the alarm centre is activated, the exit
delay time starts. The delay time runs until
a button connected to a control unit is
pressed, which ends the exit delay time
manually. The exit delay time ends seven
seconds after the button is pressed.
A=Final Door
After the alarm centre is activated, the exit
delay time starts. The delay time runs until
a zone with the entry/exit property is
closed. The exit delay time ends seven
seconds after the zone is closed.
A=Lock Set
After the alarm centre is activated, the
delay time starts. The delay time runs until
a zone with the entry/exit property is
closed and, after the zone has closed, a
contact connected to the control unit is
opened.
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
.
040 System Rearm
To change the property of the siren duration:
1. On the control unit, enter:
2. The LCD display shows: 040:Rearm=Never
3. Via the keypad, select from the following items and
press:
Rearm=Never
If an alarm is triggered, the alarm is
sounded until the defined alarm time of
the external signaller. If a second sensor
0
reports another alarm following expiry of
the defined alarm time, no second alarm
is triggered.
Rearm 1-4/Always
If an alarm is triggered, the alarm is
sounded until the defined alarm time of
the external signaller. The alarm centre
1-4
rearms itself once, twice, three times or
always, depending on the value entered.
A new alarm reports triggers a new alarm.
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
52
.
040
.