Publicité
Les langues disponibles
Les langues disponibles
Please read the operating instructions of the SE1000. Please
take care that you use the pulse setting for the keyswitch.The
circuit shown above enables you to activate/deactivate the
alarm system by turning the key in either direction. Here too,
the tamper line is not yet connected to the system. The setting
of the relais outputs and additional switch outputs is shown
later.
In the following, we show you the wiring of the tamper line.
Make sure that you connect all tamper contacts of the
individual components in series. The siren and flashlight are
an exception here since a special tamper connection is
provided on the equipment. The following diagram of the
motion sensor and key switch shows the connection of the
tamper contacts. The door contact sensor has no tamper
connections!
If you just want to use sensors without a tamper contact, insert
a jumper between COM and A/T on the alarm system.
Before programming the equipment, read the following
description of how to connect the siren and flashlight to the
TERXON M. For this purpose, we use the SG1650.
The tamper line of flashlight and siren is connected via a
separate tamper contact to the equipment. If you do not want
to use an external signalling device, place a jumper between
TR and GND (0V) of the alarm centre. The following diagram
shows the connection of the SG1650 to the TERXON M:
This completes the connection of the equipment.
We now come to the programming of the alarm equipment.
Make sure than the tamper contacts of all components are
closed before you connect the equipment to the power supply.
Proceed as follows:
1. Connect the 12V battery (7.0 Ah) to the contacts of the
alarm centre (note the colour code:
red = +12V, black = 0V).
2. Using a screwdriver, short-circuit the two pins of the kick-
start jumper (see p. 14).
3. The green LED for the power supply (
flash and the buzzers of the control units can be
activated. You can ignore the display messages.
4. Enter the factory-set user code.
. You can ignore the display messages.
This is:
1234
5. First close the housing of the burglar alarm panel
securely before switching on the 230V voltage.
6. Switch on the 230V mains voltage to the burglar alarm
panel.
7. The green LED for the voltage (
constantly.
25
UK
) begins to
) now lights
Publicité
