Abus TERXON M Instructions D'installation page 163

Unset 2
This output is activated for a definable
time period (command 170) if the alarm
31
centre is deactivated completely (A) or
internally (B), (C) or (D) (command 171).
Unset 3
This output is activated for a definable
time period (command 170) if the alarm
32
centre is deactivated completely (A) or
internally (B), (C) or (D) (command 171).
Unset 4
This output is activated for a definable
time period (command 170) if the alarm
33
centre is deactivated completely (A) or
internally (B), (C) or (D) (command 171).
Fire
This output is activated if a fire alarm is
triggered. The output remains active until
34
the alarm is deactivated.
PA
This output is activated if a fire alarm is
triggered. The output remains active until
35
the alarm is deactivated.
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
082 Relay output OP2
To change the behaviour of relay output OP2 on the
alarm centre PCB:
1. On the control unit, enter:
2. The LCD display shows: 082: Strobe
3. Via the keypad, select from the items described
above and enter the function accordingly:
083 Transistor output OP3
.
082
67
To change the behaviour of transistor output OP3 on the
alarm centre PCB:
1. On the control unit, enter:
2. The LCD display shows: 083: Set Latch
3. Via the keypad, select from the items described
above and enter the function accordingly:
085 Burglary output
To change the behaviour of the transistor output on
burglar alarms:
1. On the control unit, enter:
2. The LCD display shows: 085: Burg=Latched
2. Via the keypad, select from the following items and
press:
Burg=Latched
The output remains activated until the user
00
or programmer resets the alarm centre.
Burg=Rearm
The output is reset following expiry of the
01
defined siren duration. It can be
reactivated in the event of a new alarm.
4. Confirm your input. On the control unit, enter:
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
086 Additional entry delay
To change the behaviour of the entry delay time:
1. On the control unit, enter:
2. The LCD display shows: 086:Dual Ply OFF
3. Via the keypad, select from the following items and
press:
Dual Ply OFF
An alarm is triggered following expiry of
0
the entry delay time.
Dual Ply ON
1
An internal alarm is triggered following
083
085
.
086
UK