Troubleshooting - Fagor LUX LCD Manuel D'utilisation

Troubleshooting

If the LUX™ LCD detects an internal error or a wrong connection, it will show
an error code on the display panel and will stop functioning. These codes will
allow you to identify the cause of the error and help you find the solution to the
problem. If the error persists, please call our customer service department for
assistance at 1-800-207-0806.
E1: Internal circuits have disconnected.
Self-help: Call our customers service department for assistance.
E2: The internal sensor has short-circuited or the unit is
overheating.
Self-help: Try to cool the unit by turning it off and unplugging as well
as removing the cooking pot.
E3: Unit is overheating.
Self-help: Try to cool the unit by turning it off and unplugging as well
as removing the cooking pot. If the E3 message persists,
the cooking pot or heating plate may be deformed. You will
need to contact our customer service department.
E4: Pressure switch has malfunctioned.
Self-help: Check the cooking pot for warping. Check the heating
plate for any food residue.
Problem
• Please be advised that the lid can't be opened until the
The lid cannot floating valve drops down.
be opened at • Make sure you turn the regulator to steam until all
the end of the internal pressure is released and the lid opens easily.
cooking cycle • If this occurs frequently, the gasket may need to be
adjusted.
• Close the lid correctly ensuring there is no gap between
lid and base.
Steam is
• Ensure the silicone gasket is clean, free from damage or
escaping from
cracks and is properly inserted.
the lid
• If problem persists, call our customer service
department.
• Close the lid correctly ensuring there is no gap between
lid and base.
Self-locking • Ensure the silicone gasket is clean, free from damage or
pin does not cracks and is properly inserted.
rise • Ensure that the self-locking pin can move freely.
• If problem persists, call our customer service
department.
Easy Solution
38
• Ensure that the pressure regulator valve is properly
placed in its housing.
Cooker is not
• Add more liquid/food to the bowl. There should be a
getting to
minimum of 1 cup of food and liquid in total.
pressure
• If problem persists, call our customer service
department.
• When the lid is locked, ensure the self-locking pin is
properly secured.
• Ensure that the pressure regulator valve is properly
Timer will not placed in its housing.
count down • Add more liquid/food to the bowl. There should be a
minimum of 1 cup of food and liquid in total.
• If problem persists, call our customer service
department.
• Ensure the cooker is on a flat, level surface and that
Water is
the condensation drip cup is installed on the side of the
collecting on
cooker.
the countertop
• Empty the condensation drip cup.
• Ensure that the lid is on the correct position. For Brown
and Sauté the lid needs to be off. If the lid is closed under
The unit is
these functions the unit will beep and an icon will indicate
beeping and
to open the lid. For all other functions, the lid must be
not turning on
closed. If the lid is open the unit will beep and an icon will
indicate to close the lid.
Floating Valve Installation
Floating Valve
Floating Mini Gasket
Figure: Floating valve Installation
Insert the floating valve from the top of the lid and secure it in place with the washer from
the bottom of the lid.
Floating
Floating Mini Gasket
39