Engine Oil; Checking Oil Level And Adding Engine Oil - probst POWERPLAN PP Manuel D'utilisation

ENGINE OIL

CAUTION
To avoid personal injury:
A Be sure to stop the engine before
checking and changing the engine
oil and the oil filter cartridge.
A Do not touch muffler or exhaust pipes
while they are hot; Severe burns
could result. Always stop the engine
and allow it to cool before conducting
inspections, maintenance, or for a
cleaning procedure.
A Contact with engine oil can damage
your skin. Put on gloves when using
engine oil. If you come in contact
with engine
immediately.
A Be sure to inspect the engine, locating it on a level
place. If placed on gradients accurately, oil quantity
may not be measured.
BChecking oil level and adding engine oil
1. Check the engine oil level before starting or more
than 5 minutes after stopping the engine.
2. Remove the oil level gauge, wipe it clean and
reinstall it.
3. Take the oil level gauge out again, and check the oil
level.
1ABABAAAP148A
(1) Oil filler plug
(2) Oil level gauge
oil, wash it off
[Lower end of oil level gauge]
(A) Engine oil level within this
range is proper.
PERIODIC SERVICE
4. If the oil level is too low, remove the oil filler plug, and
add new oil to the prescribed level.
5. After adding oil, wait more than 5 minutes and check
the oil level again. It takes some time for the oil to
drain down to the oil pan.
Engine oil quantity
Model
D1005-E4, D1105-E4
D1305-E4
V1505-E4
Oil quantities shown are for standard oil pans.
A Engine oil should be MIL-L-2104C or have
properties of API classification CF or higher.
Change the type of engine oil according to the
ambient temperature.
above 25°C (77°F)
-10°C to 25°C (14°F to 77°F)
below -10°C (14°F)
A When using oil of different brands from the previous
one, be sure to drain all the previous oil before
adding the new engine oil.
15
Quantity
5.1 L (1.35 U.S. gals.)
5.7 L (1.51 U.S. gals.)
6.0 L (1.59 U.S. gals.)
SAE30 or SAE10W-30
SAE15W-40
SAE10W-30
or SAE15W-40
SAE10W-30