Suzuki DF100A Manuel Du Propriétaire page 45

NOTICE
Improperly loosening the filter cup can cause
sensor lead wire damage.
• Be careful not to twist the sensor lead wire
when removing the filter cup.
• Disconnect the lead wire connector before
removing the filter cup.
4. Push the connector lock tab "a", then discon-
nect the water sensor lead wire connector
4.
"a"
5. Place a rag under the filter before removal to
catch any spilled fuel.
6. Separate the filter cup 5 from the cap 6 by
turning the filter cup counterclockwise.
42
All manuals and user guides at all-guides.com
7. Drain the fuel and water in the filter cup into
8. Pull out the filter element 7. Inspect the filter
9. Wash the filter element with clean solvent
10. Reinstall the seal ring and filter element in
11. Verify that the O-ring is in place in the top of
12. Connect the water sensor lead wire connec-
13. Reinstall the fuel filter with bracket by secur-
14. Restart the engine and check that there are
NOTE:
If any water exists in the fuel filter cup, remove
the cup and drain the water. Always dispose of
excess fuel safely. For questions, consult your
authorized Suzuki Marine Dealer.
a suitable container.
element 7, O-ring 8 and seal ring 9 for
damage. If they are damaged, replace them.
and dry it.
their original positions.
the filter cup and screw the filter cup back
into place.
tor 4.
ing the bolt and nut.
no leaks around the fuel filter.