Trim Tab Adjustment; Throttle Tension Adjustment; Idle Speed Adjustment; Setting Of Tilt Upper Limit Position - Suzuki DF100A Manuel Du Propriétaire

TRIM TAB ADJUSTMENT

This adjustment is used to compensate for the
possible tendency of your boat to veer slightly
to port or starboard. This tendency could be
due to such things as propeller torque, motor
mounting position, etc.
To adjust the trim tab:
1. Loosen the bolt A that holds the trim tab in
place.
2. If the boat tends to veer to port, move the
rear end of the trim tab toward the port side.
If the boat tends to veer to starboard, move
the starboard side.
3. Tighten the bolt that holds the trim tab in
place.
After adjusting the trim tab, check to see if the
boat still tends to veer to one side. If necessary,
readjust the trim tab.
16
All manuals and user guides at all-guides.com

THROTTLE TENSION ADJUSTMENT

The tension of the remote control handle can be
adjusted according to your preference. To
increase the tension, turn the throttle tension
adjuster A clockwise. To decrease the tension,
turn the adjuster counterclockwise.

IDLE SPEED ADJUSTMENT

The idle speed has been factory adjusted
between 650 – 750 r/min in neutral.
NOTE:
If idle speed cannot be set within the specified
range, contact your authorized Suzuki Marine
Dealer.

SETTING OF TILT UPPER LIMIT POSITION

If the outboard motor contacts the motor well of
the boat during full tilt up operation, the upper
limit setting should be reset.
Perform this set-up after the current position
setting has been canceled, as explained in the
following procedure.
CANCELING THE TILT UPPER POSITION
LIMIT SETTING
1. Turn the ignition key to the "ON" position.
2. Pull out the emergency stop switch lock
plate.