Drive Chain Inspection - Sym MAXSYM TL 500 Manuel D'utilisation

 Clean the terminals ○,
 Install the front right cover (page 40).
 To install the battery, do in the reverse order of the above instructions.
Battery type
TTZ-10S
Battery Maintenance
Keeping the battery fully charged is the owner's responsibility. If you failed to do so, it can cause battery
failure and leave you stranded. If you ride the scooter rarely, inspect the battery voltage weekly with a
voltmeter. If the voltage drops below 12.0 V, use a suitable motorcycle battery charged to charge the
battery. Follow the instructions of the battery charger to charge the battery. Contact your authorized SYM
dealer for suitable battery chargers.
WARNING:
• Electrolyte is poisonous and dangerous since it contains sulfuric acid that can cause severe damage.
Avoid any contact with human body or clothing, always protect your eyes when working with a
battery.
• A battery produces explosive hydrogen gas; keep sparks, flames away from the battery and provide
well ventilation when charging it.
• Keep children away from the battery.

Drive Chain Inspection

Drive Chain Slack Inspection
Inspect the chain slack before riding.
 Turn ignition switch off and set the scooter upright with its main stand.
 Remove the 2 screws ○,
 Rotate the rear wheel to find the tightest position of the chain and measure the chain slack ○,
pushing up and pulling down the chain midway between the front sprocket and rear sprocket.
Drive chain slack
Standard: 10~15 mm
○
,B
by using solution of baking soda and water.
D
and the 2 bolts ○,
A
○
,A
○
,C
○
,A
to remove the outer lower chain guard.
B
○
,B
○
,A
42
by
A