Coolant Level Inspection / Filling - Sym MAXSYM TL 500 Manuel D'utilisation

Coolant Level Inspection / Filling

This scooter is filled with high quality coolant that is designed for the cooling system in the factory. It
contains a 50% solution of ethylene glycol based antifreeze. Position the scooter on level ground and in an
upright position. The coolant inspection window ○,
coolant level must be between the "F" ○,
is at the "L" mark.
 Pull up the tip of the right front floor panel mat ○,
 Open the reserve tank cap ○,
 Reverse the above steps to restore.
NOTE :
• You can add soft water to the coolant reserve tank in an emergency, it must be restored to the correct
mixture ratio afterwards.
• If you have to add coolant often, the cooling system may have a leakage problem, have your scooter
checked by an authorized SYM dealer.
WARNING:
• Never remove the radiator cap when the engine is hot.
can be seen on the right side of the under spoiler. The
A
and "L" ○,
A B
○
,A
A
to fill in coolant.
A
36
marks. Top up the coolant carefully when the level
○
,a
○
,b
and remove the maintenance cap ○,
○
,B
○
,A
○
,A
from its tip.
B