Front/Rear Brake Lever - Sym MAXSYM TL 500 Manuel D'utilisation

○
Passing Light Button
,A
When pushing the passing light button
the vehicle ahead that you are about to pass. The passing light is shut off as soon as the button is
released.
○
Dimmer Switch
,B
High and low beam can be selected with this switch. When the headlight is on high beam
beam indicator light goes on (page 10).
High beam
Low beam
○
Menu Switch
,C
The menu buttons are used to control the TFT display on the combination instrument. Please refer to
page 11.
○
Turn Signal Switch
,D
When the turn signal switch is turned to the left
and off. To stop blinking, push the switch in.
○
Horn Button
,E
When the horn button is pushed when the ignition switch is turned on; the horn sounds.

Front/Rear Brake Lever

This scooter is equipped with four-position adjustable front/rear brake levers for fitting different hand sizes.
To adjust the brake levers, do the below steps:
 Push the brake lever forward ○,
 Turn the adjuster ○,
lever forward.
 Release the brake lever and check that the lever operates correctly.
, the high beam indicator light goes on to signal the driver of
○
,a
.
a
until the number (position) aligns with the indicative mark ○,
A
or right , the corresponding turn signals blink on
○
,A
○
,B
23
, the high
while pushing the
B