Right Handlebar Switches; Left Handlebar Switches - Sym MAXSYM TL 500 Manuel D'utilisation

Right Handlebar Switches

○
Engine Stop Switch
,A
This switch should normally remain in the
to the position to stop the engine.
NOTE :
• Even though the engine stop switch can stop the engine, it does not turn off all the electrical circuits.
Normally the engine stop switch should be used to stop the engine.
○
Hazard Switch
,B
Push the switch left to
turn signal indicators will blink.
NOTE :
• Do not use the hazard lights for a long period of time, or the battery may become totally discharged.
• If you turn the ignition switch off without deactivating the hazard lights, the hazard lights cannot be
deactivated unless you turn the ignition switch on.
○
Starter Button
,C
This starter button operates the electric starter when the engine is not running. Turn the ignition switch on;
push this button while holding the front or rear brake lever to start the engine.
NOTE :
• This scooter is equipped with a permanently lit headlight; the position light, tail light, and the license plate
light will light up once the ignition switch is turned on. The above mentioned lights cannot be turned off.
• Do not leave the scooter behind too much time after turning the ignition switch on.

Left Handlebar Switches

position for the scooter to operate. In an emergency, switch
position with the ignition switch in "On" position. All the turn signal lights and
○
,A
○
,B
○
,A
○
,B
○
,C
○
,C
○
,D
○
,E
22