Blackmagic Design Ultimatte 12 Manuel D'exploitation page 46

To delete a file
1
From the saved files list, touch the file name to be deleted. The
name will be highlighted and will appear in the filename box.
2 Press the delete button to remove the selected file from the files list.
3 A prompt will ask for you to confirm the action. Select 'yes' to delete, or 'no' to cancel.
4 Repeat the process to delete other files.
5 Press the close button to exit the files window.
To rename a file
1 If the new file name is a modification of an existing one, select that file name from
the list by highlighting it. The selected file will appear in the filename box.
2 Touch the display in the filename box inside the files window. The prompter will appear.
3 Using the on screen Keyboard, or an external keyboard,
make the desired file name changes.
4 Press the rename button inside the files window. The button will display 'renaming', until
the process is completed. The new name will replace the old one in the saved files list.
5 Press the close button to exit the files window.
Assigning a File
This process assigns additional uses to a saved file. A saved file can be assigned to:
Custom Power Up
On standard power up, Ultimatte 12 will be set to factory default setting. If a different power up
setting is needed, a saved file with these settings can be used as a custom power up default.
The 'custom power up enabled' box must be checked in order to use the selected file settings
as power up defaults.
User Default
When the file clear button on your Smart Remote 4 is pressed, most of the controls and buttons
of Blackmagic Ultimatte 12 are set to default settings. If an alternate set of default settings is
desired, a saved file with these settings can be used as a user default file. Pressing 'ALT file
clear' will use the assigned file to set the custom default settings.
Quick Save
The quick save files are temporary files easily accessed from the Smart Remote 4. At any time,
a setup can be stored as a quick file, and then recalled when needed directly from the
dedicated buttons on the Smart Remote 4. Additionally, any of the saved files in the system can
be loaded into any one of the 5 quick files by assigning the selected file to the desired quick
save location number.
To assign a file:
1 From the saved files list, select the file name to be assigned. The
name will be highlighted and will appear in the filename box.
2 From the 'assign to' drop down box, select the assignment for the highlighted file.
3 Repeat steps 1 and 2 for additional assignments.
4 If needed, check the 'custom power up enable' box.
5 Press the close button to exit the files window.
Saving and Loading Preset Files 46