Publicité
Les langues disponibles
Les langues disponibles
STANDARD SLINGS
MODEL NUMBERS
STD. EXTRA
WIDE
9042
9043 XW
9044
9045
9046
9047 XW
9047P
9048
9049
Invacare slings are designed specifically for use with Invac-
are Patient Lifts and made to support the patient during lift
and transfer procedures. Slings attach to the lift with either
adjustable straps or chains (interchangeable). The slings
are reinforced at all points of attachment for safety. The
fabrics used in these slings are of very durable materials
that resist deterioration from exposure to moisture and laun-
dering. This design will accommodate patients of heavy or
light weight with support from the shoulders to the knees.
The contour shape provides comfort during the lift by avoid-
ing the bulk of the excess material between the back and
the seat sections.
Fabric
The fabric has a smooth inner side. The outer side has
binding tape around the pocket.
NOTE: Always place the sling under the patient with
the smooth side next to the body.
Sling fabrics are offered in a choice of two (2)
materials. Polyester fabric is very durable for use and laun-
dering and is preshrunk and dyed a blue color.
Open polyester mesh fabric is an exceptional material that
provides safety and comfort for the patient. The open mesh
weave of the fabric is dyed, preshrunk and durable for use
and laundering. It provides considerable traction to resist
slipping and sliding during use.
NOTE: Laundering should always be done with dark
colors.
WARNING
After each laundering, inspect sling(s) for wear,
tears, and loose stitching.
STANDARD SLINGS
DESCRIPTIONS
Polyester
Polyester w/Commode
Opening
Polyester w/Headrest
Polyester w/Commode
and Headrest
Polyester Mesh
Polyester Mesh
w/Commode Opening
Polyester Mesh
w/Commode Opening
Polyester Mesh w/Headrest
Polyester Mesh w/Com-
mode and Headrest
Body
Slings may be ordered at the time of purchase with a
commode opening in the seat section for use over a toilet
or a commode chair. Slings may also be ordered with a
headrest for additional upper body support.
Each sling includes four (4) metal support bars that have
a hole at the center to attach the "S" hook.
When shipped from the factory, these reinforcing metal
support bars are enclosed in the sling pocket with the
hole exposed.
Positioning the Sling (WITHOUT Headrest)
(FIGURE 1)
1. Position the patient in the center of the bed and laying
flat on his/her back.
2. Fold the sling in half (length-wise) and place
the fabric sections of the sling beside the patient.
FIGURE 1 - POSITIONING OF THE STANDARD
4
SLING
Publicité
