Draining The Discharge Tank; Programmi Di Test - Faro NISEA Basic Mode D'emploi

Emergency manual filling
- Insert the part of the hose with the quick coupling into the hole (9 fig. 1)
- Insert the funnel into the other end of the hose and pour in a maximum of 2 litres of distilled water.
- In case of connection to the water supply, the loading tank is filled automatically by pressing the activation
button on the previous screen (18 fig. 2).

4.6.2 Draining the discharge tank

- Insert the end of the hose without the quick coupling into a container to collect the drained water.
- Insert the quick coupling into the hole (7 fig. 1) and position the container under the autoclave to drain the tank.
- Drain the water in compliance with the waste disposal regulations in force.
4.7
- Possibility to use the drain tank outlet, placed at the back (15 fig. 1)

4.7 Programmi di test

01 Select the "Test cycles"menu
02 Alternatively, directly select "Last test run" and go to step 04
03 Select the desired cycle
04 Screen with all the parameters of the selected cycle
05 (Optional) you can open the door to insert other instruments
06 (Optional) Select the programmed start button to set the start time
07 Start the test cycle
08 (If anebled) enter the user PIN.
On confirming, the test cycle will start.
09 You can use the green bar to monitor the cycle progress.
10 When the cycle finishes, press the confirm icon to return to the
Home screen.
11 You can stop the cycle manually by holding done the
"STOP CYCLE" button for 3 seconds. Wait for the machine
to be put in a safe condition and press the confirm icon (12)
and then press Home to return to the home screen.
*Option 06 is only available in the Premium version
*Opzione 06 disponibile solo nella versione Premium
36
Programmi di test
59 59