Binding; Transmitter Setup - Spektrum SPMR1010 Manuel D'utilisation

Binding

The DXS and your receiver must be bound to each other before they will
operate. Binding is the process of teaching the receiver the specific code of the
transmitter so it will only connect to that specific transmitter.
1. Push and hold the bind button on the receiver while powering ON the
receiver. Release the bind button once the orange LED starts to flash
continuously, indicating that the receiver is in bind mode. The AR410
receiver will also enter bind mode if you power ON the receiver and then
press the bind button before the receiver has connected to any transmitter.
2. With the throttle in the low position, push and hold the A button while turning
the transmitter ON to put the
transmitter in bind mode.
3. After you set up your model,
always rebind the transmitter
and receiver to set the desired
failsafe positions.

Transmitter Setup

The DXS transmitter has reversible channels with trim programming, and
additional programming options with a USB programmer (SPMA3065).
Trim programming is a special setup mode on the DXS. You can only enter trim
programming at power up. Normal control operation will not resume until you
power the transmitter OFF and then back ON again normally.
CAUTION: If your aircraft has an electric motor, always remove the
propeller or disconnect the motor before entering trim programming
mode. Do not fly your aircraft while the transmitter in is trim programming
mode. Trim programming is intended for setup use only and is not intended
to be used for operation.
Trim Programming
1. Begin with the DXS bound to your receiver.
2. Power OFF the DXS and leave the receiver powered ON, if you want to see
the results of the control changes you are making.
3. To enter trim programming mode, push and hold the elevator and throttle
trim buttons up awhile you power ON the DXS.
BIND Status
Ready to Bind
Bind Complete
The RGB LED on the transmitter
will illuminate green to indicate
the transmitter is in trim
programming mode.
DXS and AR410
Flashing Orange LED
Solid Orange LED
EN
7