Step 5 Move The Refrigerator; Step 6 Replace The Freezer Drawer; Step 7 Level The Freezer Drawer - Monogram ZWE23ESNSS Instructions D'installation

STEP 5 MOVE THE REFRIGERATOR

• Place a piece of the carton or soft cloth against the
side panel of the refrigerator to pad and protect the
stainless steel finish.
• Place the refrigerator on the handtruck with a side
against the truck only.
• Move the refrigerator indoors. Place refrigerator close
to the installation location.
STEP 6 REPLACE THE FREEZER
DRAWER
ATTACH AND SECURE
THE DRAWER FRONT
TO THE SLIDES
A. Pull the slide
Mechanism to full
extension using both
hands simultaneously.
B. Remove the basket
resting on the slides.
CAUTION
Lifting Hazard
Freezer door is heavy Use both hands to secure
the door before lifting.
Avertissement de porte
ATTENTION
lourde.
La porte du compartiment congélateur est lourde.
Utilisez les deux mains pour stabiliser la porte avant de
la soulever.
PRECAUCIÓN
La puerta del freezer es pesada. Use ambas manos
para asegurar la puerta antes de levantar la misma.
C. Lift the freezer door and place it on the slide
mechanism
D. Replace the attachment screws and torque the
screws to 65 in-lb (7.34 N-m).
E. Adjust freezer door gap if necessary.
31-1000602 Rev. 0
Installation Instructions
Riesgo al levantar la
puerta
Align and insert tab on
freezer door bracket
into slot on freezer slide
bracket.
STEP 7 LEVEL THE FREEZER
DRAWER
A. Locate the height adjuster cam in the freezer door.
Slightly loosen the three door attachment screws on
both sides using an 8mm hex socket driver.
B. Locate and loosen the cam screw using the 8mm
socket driver.
Cam
Screw
C. Lift the door on the side requiring adjustment,
rotate the cam to required position.
D. After adjustment tighten the 3 attachment screws
using to 65 in-lb (7.34 N-m).
0 - Initial position
1 - Lift by 0.050"
(0.127 cm)
1 - Lower by 0.050"
(0.127 cm)
-2 - Lower by 0.100"
(0.254 cm)
-3 - Lower by 0.150"
(0.381 cm)
11