Step 5 Slide Unit Into Enclosure; Step 6 Remove Toekick And Vent; Step 7 Level Refrigerator - Monogram ZIK30GNNII Instructions D'installation

STEP 5 SLIDE UNIT INTO
ENCLOSURE
Roll the unit into the enclosure, being careful not to
pinch the water line or power cord.
the front edge of the anti-tip bracket over the unit.
If space allows, you may also bend the front edge of
the bracket upward slightly, allowing it to clear the
back of the unit.
Remove Top-Center trim cover from unit.
Secure the unit to the Anti-tip bracket using both
machine screws & washers to engage the threaded
inserts in the anti-tip bracket.
Hand start the screws until unit is in desired location
within the install space.
Finalize unit install by tighening the screws fully.
Reinstall Trim cover.
Installation Instructions
STEP 6 REMOVE TOEKICK AND
VENT
The toekick must be removed to access
the leveling leg system.
Remove band around EPS block in front of toekick.
Remove and dispose of EPS block.
Remove the solid portion of the toekick by pulling
forward.
Place the toekick, vent and screws out of the way so
you will have them for reinstallation.
Vent
Screws
(behind
toekick)
Screw

STEP 7 LEVEL REFRIGERATOR

All models have 4-point leveling. The front is supported
wheels. Both are accessible from the front of the
refrigerator.
hex nut located above the front wheels. Turn
counter clockwise to raise or clockwise to lower the
refrigerator.
Adjust height of refrigerator to match installation
cutout opening. The refrigerator should be level and
plumb with cabinetry.
NOTICE: The rear leveling wheels and front leveling
installer should elevate the refrigerator on a sheet of
plywood or runners. Cabinetry trim could also be added
across the top of the opening to shorten the opening.
will damage the front leveling legs and the rear leveling
wheels.
14
Toekick
Hex Nut Adjusts
Up
Rear Wheels
Up
Leveling Leg
31-1000169 Rev. 1
Vent
Screw