Main Independent Controls; Controls On Left Handlebar - APRILIA SCARABEO 250 Mode D'emploi

MAIN INDEPENDENT CONTROLS

CONTROLS ON LEFT HANDLEBAR

NOTE
The electric components only
operate when the ignition switch is in the
" " position.
1) HORN BUTTON ( )
Press this button to operate the horn.
2) TURN INDICATOR SWITCH (
To indicate the turn to the left, move the
switch to the left; to indicate the turn to
the right, move the switch to the right.
Press the switch to cancel the signal.
30 use and maintenance Scarabeo 250
3) DIMMER SWITCH (
BEAM FLASHER PUSH BUTTON
(PASSING )
if the dimmer switch is in position "
the high beam comes on, while if it is in
position " ", the low beam comes on.
The high beam flasher is operated by
pressing the dimmer switch to position
(PASSING ).
NOTE
Release the dimmer switch to
turn off the high beam.
C O N T R O L S
HANDLEBAR
NOTE
The electric components only
operate when the ignition switch is in the
" " position.
1) START PUSHBUTTON (
Wh e n t h e s t a r t e r b u t t o n "
pressed, the starter motor will crank the
engine. For the starting procedure, see
)
page 45 (STARTING)
2) ENGINE STOP SWITCH (
- ) / HIGH
",
O N R I G H T
Do not operate the engine stop switch
" -
This switch serves as a safety or
)
emergency switch.
" i s
With the switch in position "
possible to start the engine; the engine
can be stopped by moving the switch to
position " ".
- )
W i t h t h e e n g i n e s t o p p e d a n d t h e
ignition switch in position "
battery may run down.
W h e n t h e v e h i c l e h a s c o m e t o a
standstill and you have stopped the
engine, set the ignition switch to
position " ".
2
1
" while riding.
" , the
", it is