Publicité
NEVADA 750
20.Clip
21.Lambda Probe
22.Spacer
23.Cap
24.Gasket
25.Protection
26.U-bolt
27.TBEI screw
28.Bushing
29.Insulating washer
Removing the tail pipe
The engine and the exhaust system components get very hot and remain in this condition for a certain
time interval after the engine has been switched off. Before handling these components, make sure that
you are wearing insulating gloves or wait until the engine and the exhaust system have cooled down.
Removing the lambda sensor
Downloaded from
www.Manualslib.com
•
Loosen the clamp between the ex-
haust end and the catalytic converter.
•
Unscrew and remove the muffler fixing
nut and collect the screw and the bush-
ing.
•
Remove the exhaust end.
•
Disconnect the lambda probe connec-
tor.
manuals search engine
Chassis
CHAS - 121
Publicité
Chapitres
