Publicité
Power supply
•
•
Co rate adjustment
It is not possible to adjust CO (time of injectors opening) but just resetting the self-adjustable parameters
in case the throttle body is replaced because it is worn.
Iso screen page
ISO
This screen page shows general data regarding
the control unit, for example software type, map-
ping, control unit programming date
Engine parameter reading screen page
ENGINE PARAMETER READING
This screen page shows the parameters meas-
ured by the several sensors (engine revs, engine
temperature, etc.) or values set by the control unit
(injection time, ignition advance, etc.)
P SUPP - 78
Downloaded from
www.Manualslib.com
Take the engine to the prescribed temperature: 70 - 80°C (158 - 176 °F).
Operating the by-pass screws, adjust idle: 1100 ± 50 rpm.
Specification
Mapping
E
NGINE PARAMETER READING SCREEN PAGE
Specification
Throttle
TPS Trimmer
Precise throttle position
manuals search engine
ISO DISPLAY
Desc./Quantity
Desc./Quantity
Value corresponding to the throttle when closed (approximate
value between 4.5 and 4.9°) (left throttle supported by the end
of stroke screw). If a different value is read, it is necessary to
activate the parameter "Throttle positioner autodetection" and
obtain this value.
Supplementary parameter related to throttle keying in calibra-
Throttle opening angle in degrees: once the throttle position
self-learning is carried out, it falls within the following value
range: 3.1° ± 0.4°.
NEVADA 750
-
tion.
Publicité
Chapitres
