Fixing The Base To The Support; Connection Of The Connector Board; Connection Of The Power Supply Line - Videotec ULISSE MAXI NETCAM Manuel D'instructions

7.2.2 Fixing the base to the support

Use the screws and the washers supplied
with the base.
After having positioned gasket (01), fasten base (02)
on support (03) using screws, toothed spring washers
and the rings for screw (04).
01
04
Fig. 25
01
04
Fig. 26
Align the 3 notches on the base with those on the
support as shown in the following figure.
Fig. 27
Apply a generous amount of thread locking
compound into the screw holes (Loctite
243®).
Pay attention to the fixing. Tightening
torque: 6Nm.
20
02 03
02
03
7.2.3 Connection of the connector
board
The following is a description of the connector board
located inside the P&T base.
Fig. 28

7.2.3.1 Connection of the power supply line

Depending on the version, the device can be
provided with different power supply voltages. Their
value is shown on the product identification label (4.2
Product markings, page 10).
Electrical connections must be performed
with the power supply disconnected and
the circuit-breaker open.
CAUTION! The electrical system to which
the unit is connected must be equipped
with a 20A max automatic bipolar circuit
breaker. The minimum distance between
the contacts must be 3mm (0.1in). The
circuit breaker must be provided with
protection against the fault current
towards the ground (differential) and the
overcurrent (magnetothermal).
Ethernet
CN4
CN7
CN1
MNVCUPTMAXIR_1430_EN