Selecting Set-Point Pressure For Joint Pressure Estimation And; Control (Jpec); Table 4. Selecting Joint Pressure Set-Point - Johnson & Johnson DePuy Synthes FMS VUE II Manuel De L'opérateur

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 293
6.1.2 selecting set-point pressure for Joint pressure
estimation and Control (JpeC)
Before pressing the RUN/STOP pad to start the pump, adjust the joint pressure set-point on the
display . Table 4 provides instructions for changing the joint pressure set-point .
to...
Display the preset pressure
(70 mmHg) when the pump
is regulating pressure .
Increase the pressure in
increments of 5 mmHg .
Decrease the pressure in
increments of 5 mmHg .
nOte: Brackets around the pressure display indicate that the pump is in BLOODSTOP mode.

Table 4. Selecting Joint Pressure Set-Point

do this...
Press once on either of the
pressure pads next to the
display .
Press "+"
Press "–"
33
system response
Displays selected pressure .
When selected, displays
selected pressure .
When selected, displays
selected pressure .

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

284004

Table des Matières