Fault Code - Johnson & Johnson DePuy Synthes FMS VUE II Manuel De L'opérateur

fault Code

FC004 Pressure sensor/electronics
problem detected
FC005 Shaver motor over-current fault
FC006 Shaver motor controller fault,
caused by thermal fault, or over-
current fault
FC007 Hand-piece 5V over-current fault
FC008 Foot-pedal 5V over-current fault
FC009 Irrigation motor over-current fault
fault description
57
fault Correction
Pressure sensors readings difference
detected .
Discontinue use of the console . Contact
your DePuy Synthes representative .
Possible short circuit in shaver, replace
shaver to avoid possible damage to the
console .
Possible short in shaver or damage to
motor controller .
Replace shaver . If replacing shaver
doesn't correct issue, contact your
DePuy Synthes representative .
Possible short in hand-piece connector
or cable, replace hand-piece .
Possible short circuit in foot-pedal
connector or cable, replace foot-pedal
Possible pump motor short circuit .
Discontinue use of the console . Contact
your DePuy Synthes representative .