Start Diagnostic Tool - Dentsply Sirona CEREC AC Connect Notice D'utilisation

10 PC Diagnostic Tool

10.2 Start diagnostic tool

78
Operating Instructions for the Acquisition Unit - With CEREC Omnicam
4. Set the entry "ASM1061 Storage Controller" to "IDE Mode".
5. In the menu go to "Exit" and "Save Changes & Reset" or press
the "F10" button to save the settings.
6. Confirm the confirmation prompt with "Yes".
10.2 Start diagnostic tool
Test
Customer Diagnostics
Technician Diagnostics
Sirona Windows Diagnostics
Tip: If one of the following steps does not work, further steps can be
found in the Service Manual.
ü The PC is switched off.
1. Switch on the PC.
2. Repeatedly press the "F11" or "F8" button (in V2.2.1 - V2.2.3) until
the PC switches to the boot menu.
3. Insert the diagnostics tool CD into the drive.
4. Select the "P3: TSSTcorp CDDVDW ..." menu option.
5. Confirm your selection with the "Return" key on the keyboard.
Ä The diagnostics tool starts and a selection menu appears.
Tip: After one minute, if none of the arrow keys have been
pressed, the "Customer Diagnostics" test starts
automatically.
Suitable for
Suitable for the user, in order to
check the PC components.
Suitable for the technician, in order to
check the PC components.
Windows Stress Test, in order to test
the PC at permanent load.
66 37 479 D3492
D3492.201.07.28.02 09.2019
Dentsply Sirona