Dentsply Sirona CEREC AC Connect Notice D'utilisation page 90

Masquer les pouces Voir aussi pour CEREC AC Connect:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

10 PC Diagnostic Tool
10.4 Troubleshooting
Test
Test WDC___TYP HDD___Short
Self-Test
Test 3 Minute(s) Drive #1 __Size
of HDD__RndRd
Test ATAPI #1
00000000-000050000
Test Active
Test NET #1 SelfTest
Test Base Memory
Test Cache Memory
Test Extended Memory
Test Above 4 GB memory
86
Operating Instructions for the Acquisition Unit - With CEREC Omnicam
Test description / condition
A range of destruction-free tests on
the hard drives installed in a system
are conducted with these functions.
Controller search and read tests are
conducted to check the overall con-
dition of a drive.
Use this function to test the installed
CD-ROM-/CDR/W-/DVD drive. The
test checks the test ROM directly;
no software drivers have to be
loaded.
The test medium is the CD test tool
USB test (at least 1 USB human de-
vice must be connected; for the AC
this is usually a keyboard, trackball,
camera, and UPS mains supply).
This test provides an internal check
on all of the network cards.
The "Base RAM Test" provides a
check on the base RAM on the sys-
tem board (up to 640 KB).
This function provides a test on the
low-level memory data and the low-
level addresses in the external sys-
tem cache in order to check its func-
tion.
The "Extended RAM Test" provides
a check on the extended RAM be-
tween 1 MB and 4 GB.
The "Above 4 GB Memory Test" en-
ables you to check the extended
RAM in the range above 4 GB.
Dentsply Sirona
Action if problems occur
1. For the CEREC AC check the
setting of the ASM1061 Storage
Controller.
2. Check the hard disk's SATA
line.
3. Check the hard disk's power
supply.
4. Exchange the hard drive
including the hard drive cable.
1. Check the CD for scratches or
other dirt.
2. Check the SATA line between
the PC and DVD drive.
3. Check the power supply line
between the PC and DVD drive.
4. Replace the DVD drive.
5. Check the SATA connection
from the mainboard to the SATA
slot sheet in the PC.
6. Check the connection of the
power supply from the mains
power unit to the SATA Slot
sheet in the PC.
➢ Replace the PC.
➢ Replace the PC.
➢ Remove the memory and then
re-insert it.
66 37 479 D3492
D3492.201.07.28.02    09.2019

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Cerec ac

Table des Matières