Dentsply Sirona CEREC AC Connect Notice D'utilisation page 66

8 Maintenance
8.1 Care, cleaning, disinfection and sterilization
62
Operating Instructions for the Acquisition Unit - With CEREC Omnicam
NOTE
Only place the mirror sleeve into the container and not the entire
CEREC Omnicam.
Ensure that the mirror sleeve is placed upright in the disinfectant (with
the coated sapphire glass down) so that the solution cannot penetrate
the inside of the mirror sleeve.
5. Choose a container. Find an example on the left.
6. Cautiously fill the container to a filling level of 20mm - 25mm (
- 1 i n) under the small elongated hole (A) of the mirror sleeve when
immersed. A funnel can be used to assist with filling the liquid. Do
not spill any disinfectant. If spillage occurs please follow
disinfectant's manufacturer's safety indications for cleaning.
7. Insert the mirror sleeve in the correct position (coated sapphire
glass down).
8. Leave the mirror sleeve at least 12 minutes in the disinfectant.
While exceeding the recommended immersion time may not cause
damage to the mirror sleeve, the mirror sleeve should be removed
as soon as possible after the recommended time.
9. Remove the mirror sleeve from the container.
10. Thoroughly rinse the mirror sleeve with tap water of potable water
quality that meets Federal Clean Water Standards for at least 30
seconds. Ensure that no water is able to penetrate into the interior
of the mirror sleeve.
11. Wipe off the mirror sleeve. Use a cotton gauze moistened with tap
water of potable water quality that meets Federal Clean Water
Standards for this purpose.
12. Dry the mirror sleeve using a clean soft, lint-free cloth.
13. Store the mirror sleeve in such a way that it is protected from
contamination until the next use.
14. Carefully re-attach the mirror sleeve and allow it to lock in place
(see „Refitting the mirror sleeve [→ 55]").
Dentsply Sirona
13
/ i n
16
66 37 479 D3492
D3492.201.07.28.02 09.2019