Boston Scientific SC-6412 SCS Charger 2.0 System Kit Mode D'emploi page 16

8. Secure the Charger over the Stimulator either by pressing the adhesive to the skin over the
Stimulator, or by securing the Charger Belt. Be careful to maintain the Charger's alignment as
you tighten the Belt. Take care to not overtighten the Belt, which may result in discomfort or
accidental movement of the Charger.
Note: If you accidentally locate the patch in the wrong place, or if the Charger Belt moves out of
alignment, the Charger will start beeping again. Use a new adhesive patch or readjust the
belt to place the Charger back into position.
Note: Wearing the Charger Belt over loose fitting clothes may result in more frequent movement of
the Charger. For best results, occasionally check the Charger to make sure that it is centered
over the Stimulator. If the Charger is not centered over the Stimulator, charging time may
increase. If it moves significantly out of alignment (Figure 4), it will start beeping again.
Figure 4. Poor alignment of the Charger (outlined in grey) over the Stimulator (dotted line).
Charger Handbook
90970865-13 REV A 12 of 75