Boston Scientific SC-6412 SCS Charger 2.0 System Kit Mode D'emploi page 11

IMPORTANT: If you are outside the US, complete the following before proceeding to step 2:
Without plugging anything in your AC wall outlet, select the plug that matches your standard
AC wall outlet, then fully insert this plug into the power supply.
2. Plug the Power Supply into a standard AC wall outlet, and then plug the other end into the Base
Station connector.
3. Place the Charger in the Base Station.
When charging, you must use the Charger with either the Charger Belt or an adhesive patch
(available separately) to hold the Charger over the Stimulator. Before using the Charger Belt, refer
to the instructions for using the Charger Belt in this manual. The adhesive patches are made of
non-reactive material suitable for most sensitive skin types.
Note: Boston Scientific recommends the use of the Charger Belt for charging.
Charging the Stimulator
Charger Handbook
90970865-13 REV A 7 of 75