Boston Scientific SC-6412 SCS Charger 2.0 System Kit Mode D'emploi page 14

4. Place the Charger in the pouch of the Charger Belt so that the power button is visible through
the mesh fabric.
Figure 1. Placing the charger in the pouch
OR
If using Adhesive Patches proceed to step 7.
5. Close the pouch.
6. Place the Charger Belt around your body so that the power button and mesh fabric are facing
out. Affix the adjustable straps so that the Belt is slightly loose at first. In order to properly
use the Charger Belt, both of the straps must go through the Belt Loop. See Figure 6 in "The
Charger Belt" section of this manual.
Charger Handbook
90970865-13 REV A 10 of 75